The maintenance of Raymond mill starts with the production line, bearings lubrication, and change wear parts. All of these operations will be introduced in the following articles and it is help for clients.
The maintenance is started with the production line. It needs professional workers to pay attention. These workers' main work is to have the suitable and right start and close down operation ability. They also need to process the emergency situations, such as the suddenly card, serious vibration.
Before it works, the Raymond mill needs to have the check. All of these checks are small one, such as the electric systems electrify situation, all the screws inside the grinding mill are tightened and so on. When the Raymond mill has been used for a period of time, it needs to have a large scale check. At this time, you can depend on the machine specification or the salesman. The large scale check of Raymond mill includes changing Raymond mill roller, grinding ring and shovel, or the lubrication is less, the parts are tightened.

5 Tips To Better Maintain Your Raymond Mill
- 1. During the operation of the Raymond mill, special technical personnel should be responsible for the operation and supervision.
- 2. In order to make the Raymond grinding mill operate normally, necessary maintenance tools, grease and corresponding accessories should be prepared and checked regularly.
- 3. After the Raymond mill has been used for a period of time, it should be overhauled, and at the same time, the wearing parts such as the grinding roller, grinding ring, blade, etc. should be repaired and replaced. The connecting bolts and nuts of the grinding roller device should be carefully checked before and after use to see if If there is looseness, check whether the lubricating oil has been added enough.
- 4. When the grinding roller device is used for more than 500 hours or so to replace the grinding roller, the rolling bearings in the roller sleeve must be cleaned, and the damaged parts should be replaced in time.
- 5. The roller bearing is refueled once per shift, the central bearing of the main engine is added once every 4 shifts, and the blower bearing is added once a month. The maximum temperature rise of the bearing should not exceed 70 ℃. When the bearing is found to be overheated, the accessories such as the bearing and bearing chamber should be removed and cleaned once.
Raymond Mill Lubrication
When the Raymond mill works for a period of time, it needs to add oil in the lubrication device and needs to change the related parts. This adding oil time and all wear parts actual situation need to be recorded by professional workers. It is very helpful for clients to do the preparation work for the next lubrication or change wear parts to avoid the work faults.
Raymond Mill Parts Maintenance
After a period of time of grinding roller, it needs to change the grinding roller; clients need to clean the bearings inside the roller. It can reduce the bearing wearing and prolong the service lifetime. In roller bearing oiling manual pumps or grease gun can be used to fill up.
In Raymond mill, there are several bearing parts, such as roller bearings, bearing, blower bearing host center and so on. Each bearing's refueling needs different times and roller bearing needs to refuel before starting. Host center bearing will work for three or four classes to add oil. The hair dryer oil bearing will be once a month. Each time to bearing oiling is best can open cleaning, watch bearing have wear phenomenon and timely solve.